Miters/End Caps

Miter Strips. . . Provide a Smooth Transition at the gutter corners along with a Smooth and 
                             very Appealing End Appearance.   

Miter Strips are installed at all corners / junctions.

The detail  or installation is the same for both inside and outside corners (miters).

Miter Strips
       * Approx. 8 inches in  
            length
       * Tapered on one end to
            match gutter edge.
       * "H" shape allows for
            guard insert on both
            sides.
       * Allows for 1/2" variance in the angle or cutting
            of the guard for installation time savings.
       * Trim Miter Strip to length at the roof line and  
            should disappear under the roofing for a  
            nice - clean finished installation.  

End  Caps . . .  Close the system off to prevent birds, bees, animals, etc... from entering the
                          gutter system and nesting.

End Caps are 2.5"x 6" flat aluminum stock.
Painted Enamel  (Black) 

Each end cap will need to be individually fabricated on site because each gutter position is different than the last. 

Skill & craftmanship is needed to fabricate a snug fitting end cap and to obtain the proper desired results.